3D Histech Pannoramic 250 FLASH II User Manual page 74

Pannoramic 250 FLASH II 1.18.1 User's Guide
On this panel you can set identification features and profiles for slides as follows:
Features on the panel:
Apply one profile to all slides
•
One profile is used for all slides in a batch. Current Profile is the profile that was loaded in
Routine work / Scan Profiles. You can also select any other profile in the selection box.
Read barcode if no name is defined on the list
•
The barcode will be used as name for the virtual slide. This option will work only if no name
has been entered in the Names / Barcodes cell of the table.
Enable parsing of barcodes or defined names
•
You can define the output directory, the name and the profile to be used by barcodes. The
positions of the characters in the barcode are defined in the mask fields.
It is possible to define areas using the character '–'. Characters located at different places of
the barcode may be combined by using a comma. Mainly 2D barcodes are used for this
purpose. It is possible to use 1D barcodes, however, it can contain less information.
You can create up to five subdirectories by the barcode.
If you use long strings for defining the profile name, select Match only the beginning of the
profile name. This makes profile coding faster.
Make sure that only one profile name begins with those characters.
Example for character string analysis
May 29, 2014 – Rev. 1
Note:
Character string: PANNORAMIC_250FII_123
•
Mask: 1-10 = PANNORAMIC
•
Mask: 12-17 = 250FII
•
Mask: 1-10, 19-21 = PANNORAMIC123
•
3DHISTECH Ltd.
4 Software Description
74(137)