Pannoramic 250 FLASH II 1.18.1 User's Guide
Modes on the panel
Apply one profile to all slides
•
•
•
•
Read barcode if no name is defined on the list
•
•
Enable parsing of barcodes or defined names
•
•
•
•
•
•
Make sure that only one profile name begins with those characters.
Example for character string analysis
You can separate the character groups with any character you choose,
it will not be read by the software.
May 29, 2014 – Rev. 1
One profile is used for all slides in a batch.
Current Profile is the profile that was loaded in Routine work / Scan Profiles.
You can also select any other profile in the selection box.
The barcode will be used as name for the virtual slide. This option will work only if
no name has been entered in the Names / Barcodes cell of the table.
You can define the output directory, the name and the profile to be used by
barcodes.
The positions of the characters in the barcode are defined in the mask fields. It is
possible to define areas using the character '–'. Characters located at different
places of the barcode may be combined by using a comma.
Mainly 2D barcodes are used for this purpose. It is possible to use 1D barcodes,
however, it can contain less information.
You can create up to five sub-directories by the barcode.
If you use long strings for defining the profile name, select Match only the
beginning of the profile name. This makes profile coding faster.
Note:
Character string: PANNORAMIC_250FII_123
•
Mask: 1-10 = PANNORAMIC
•
Mask: 12-17 = 250FII
•
Mask: 1-10, 19-21 = PANNORAMIC123
•
Note:
3DHISTECH Ltd.
4 Software Description
104(137)