3D Histech Pannoramic 250 FLASH II User Manual page 76

Pannoramic 250 FLASH II 1.18.1 User's Guide
The number before M represents the magazine number. The number after M represents the
slide position. In this example, the name indicates a slide in magazine 1, position 10.
You can also define names for the slides in the table below, by entering names into the
column Names / Barcodes. You can also define profiles in the selection boxes in column
Profiles if you intend to use different profiles for slides. Current Profile is the profile loaded
in Routine Work / Scan Profiles.
If the Continuous scanning mode is activated this function is not
available.
Save entered names and assigned profiles by clicking
You can define a name before saving. The information will be saved in a CSV format:
You can export this information into Excel where you can change the data and save it again
in CSV format.
You can import previously saved names and assigned profiles by clicking
You can delete all entries from the table by clicking
May 29, 2014 – Rev. 1
Note:
1;<slide position>,<slide name>,<profile name>
.
3DHISTECH Ltd.
4 Software Description
.
.
76(137)