3D Histech Pannoramic 250 FLASH II User Manual page 61

Pannoramic 250 FLASH II 1.18.1 User's Guide
Preview toolbar
You can find the preview toolbar at the bottom of the preview image.
May 29, 2014 – Rev. 1
Areas that will be scanned
These areas are digitized on the basis of user settings (for example, Fill holes in
scan area) and not detected by the selected threshold value.
Detected sample areas that will be scanned
These areas are digitized. They are detected on the basis of the selected
threshold value.
Detected sample areas that will not be scanned
These areas are not digitized on the basis of their position (for example, they
are outside the selection box). They are detected by the selected threshold
value.
Marker
If Scan marker specified area is selected in the Preview panel, the preview
camera detects the marker pen. The inside areas appear in red color and will
be digitized.
Areas scanned in
This color is only displayed during scanning.
Figure 40 – Preview toolbar
3DHISTECH Ltd.
4 Software Description
61(137)