Installing The Controller Retention Bracket; Sliding The Controller Retention Bracket Inward And Pressing The Release Tab - IBM Storwize V7000 Unified Problem Determination Manual

SAS expander card
retention bracket
(the controller retention
bracket from step ii)
Tab
Figure 25. Installing the controller retention bracket
2
1
Figure 26. Sliding the controller retention bracket inward and pressing the release tab
3. To install the SAS riser-card and controller assembly for a tape-enabled server
122
Storwize V7000 Unified: Problem Determination Guide Version
4) Install the controller retention bracket from step i by sliding the bracket
inward 1 and pressing down the release tab into place 2 . See
Figure 26.
b. Place the front end of the SAS controller in the retention bracket and align
the SAS riser card with the SAS riser-card connector on the system board.
c. Press down on the SAS riser card and the rear edge of the SAS controller
until the SAS riser card is firmly seated and the SAS controller card
retention latch clicks into place.
One or two pins (depending on the size of the card) clicks into the corner
holes of the SAS controller card when the controller card is correctly seated.
model, complete the following steps.
Figure 27 on page 123 shows the SAS riser card in the tape-enabled server
model.