IBM Storwize V7000 Unified Problem Determination Manual page 160

About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
To remove the CD-RW/DVD drive, complete the following procedure.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. Turn off the file module and peripheral devices, then label and disconnect both
3. Press down on the left and right side latches and pull the server out of the rack
4. Remove the cover, as described in "Removing the cover" on page 87.
5. Find the CD-RW/DVD drive, and the blue release tab on the top left hand
6. From the front of the server, carefully pull the drive out of the bay.
7. Remove the drive retention clip from the drive. The retention bracket is not
8. Carefully attach the retention bracket to the replacement CD-RW/DVD drive,
136
Storwize V7000 Unified: Problem Determination Guide Version
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
power cords and all external cables.
enclosure until both slide rails lock.
corner of the CD-RW/DVD drive. Press the release tab down to release the
drive; then, while pressing the tab, pull the drive toward the front of the server.
Drive retention clip
Alignment pins
Note: The cables to the CD-RW/DVD drive do not need to be disconnected
from the CD-RW/DVD drive in order to remove the drive.
secured by any fasteners; carefully unclip the retention bracket from the
CD-RW/DVD drive, noting the point of attachment as indicated in the figure.
noting the point of attachment as indicated in the figure.