Va Safety Cover - IBM Storwize V7000 Unified Problem Determination Manual

Removing the 240 VA safety cover
The following procedure is for a field replaceable unit (FRU). FRUs must be
installed only by trained service technicians.
About this task
To remove the 240 VA safety cover, perform the following steps:
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. Turn off the file module and peripheral devices, then label and disconnect both
3. Press down on the left and right side latches and pull the server out of the rack
4. Remove the cover, as described in "Removing the cover" on page 87.
5. Remove the SAS riser-card assembly. See Removing the SAS riser-card and
6. Remove the screw from the safety cover. See Figure 44.
Screw
Safety cover
Alignment
tabs
Figure 44. 240 VA safety cover
7. Disconnect the hard disk drive backplane power cables from the connector in
8. Slide the cover forward to disengage it from the system board, and then lift it
9. If you are instructed to return the 240 VA safety cover, follow all packaging
162
Storwize V7000 Unified: Problem Determination Guide Version
If the file module requires modification of the uEFI.PCIeGenSelection settings,
you must reboot the file module for the new settings to take effect.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
power cords and all external cables.
enclosure until both slide rails lock.
controller assembly.
front of the safety cover.
out of the server.
instructions, and use any packaging materials for shipping that are supplied to
you.