Installing The Controller Retention Bracket - IBM Storwize V7000 Unified Series Problem Determination Manual

1
2
Figure 24. Removing the rear controller retention bracket
SAS expander card
retention bracket
(the controller retention
bracket from step ii)
Tab
Figure 25. Installing the controller retention bracket
3) Install the controller retention bracket from step ii by aligning the
retention bracket controller slot and then placing the bracket tabs in the
holes on the chassis, and slide the bracket to the left until it clicks into
place. See Figure 25.
4) Install the controller retention bracket from step i by sliding the bracket
inward 1 and pressing down the release tab into place 2 . See
Figure 26 on page 116.
115
Chapter 4. File module