Tape-Enabled Server Model - IBM Storwize V7000 Unified Problem Determination Manual

Release latch
Pins
SAS riser card
Figure 20. Tape-enabled server model
Installing the SAS riser-card and controller assembly
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
To install the SAS riser-card and controller assembly in the file module, complete
the following procedure.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. To install the SAS riser-card and controller assembly for a 16-drive-capable
Slots
a. Press down on the assembly release latch and lift up on the tab to release
the SAS controller assembly, which includes the SAS riser card, from the
system board.
b. Lift the front and back edges of the assembly to remove the assembly from
the server.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
server model, complete the following steps.
Figure 21 on page 120 shows the SAS riser-card and controller assembly in the
16-drive-capable server model.
119
Chapter 4. File module