IBM Storwize V7000 Unified Problem Determination Manual page 318

294
Storwize V7000 Unified: Problem Determination Guide Version
Table 44. Upgrade error codes and recommended actions (continued)
Error
Code Explanation
01C0 Asynchronous replication is
running. Stop asynchronous
replication and continue with the
upgrade.
01C1 Asynchronous replication failed to
stop. Stop asynchronous replication
and continue with the upgrade.
01C2 Failed while checking for current
running asynchronous jobs.
01C3 Could not stop CTDB.
01C4 Unable to remove callbacks
01C5 Could not reinstall Lib_Utils.
01C6 Failed while running
sonas_update_yum.
01C7 Unable to get list of cluster nodes.
01C8 Failed while running cnrsscconfig. Contact your next level of support.
01C9 Unable to install CIM
configuration.
01CA Unable to get name of cluster.
01CB Unable to install GPFS packages.
01CC Could not install platform. Upgrade
on target system.
01CD Unable to mount GPFS file systems. 1. See "Checking the GPFS file system
01CE Unable to update system security.
01CF Unable to configure node.
Action
1. Stop asynchronous replication by
typing stoprepl gpfs0 --kill.
Asynchronous replication is
considered active if in RUNNING or
KILLING state.
2. Contact your next level of support.
1. Stop asynchronous replication by
typing stoprepl gpfs0 --kill.
Asynchronous replication is
considered active if in RUNNING or
KILLING state.
2. Contact your next level of support.
1. Attempt to check status of lsrepl. If
this command is working restart
upgrade.
2. Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
Contact your next level of support.
mount on each file module" on page
171
2. Restart upgrade and see if this was a
transient issue.
3. Follow SONAS GPFS troubleshooting
documentation.
4. Contact your next level of support.
1. Restart upgrade and see if this was a
transient issue.
2. Contact your next level of support.
1. Pull both power supply cables from
subject node. Wait 10 seconds, then
plug back in. After the system
restarts, try again.
2. Contact your next level of support.