IBM Storwize V7000 Unified Problem Determination Manual page 125

your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
To replace some components or to create working room, you might have to remove
the fan-bracket assembly.
Note: To remove or install a fan, it is not necessary to remove the fan bracket. See
"Removing a hot-swap fan" on page 141 and "Installing a hot-swap fan" on page
142.
To remove the fan bracket, complete the following steps.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
2. Turn off the file module and peripheral devices, then label and disconnect both
power cords and all external cables.
3. Press down on the left and right side latches and pull the server out of the rack
enclosure until both slide rails lock.
4. Remove the cover, as described in "Removing the cover" on page 87.
5. Remove the fans, as described in "Removing a hot-swap fan" on page 141.
6. Remove the PCI riser card assemblies, as described in "Removing a PCI
riser-card assembly" on page 105.
101
Chapter 4. File module