IBM Storwize V7000 Unified Problem Determination Manual page 42

18
Storwize V7000 Unified: Problem Determination Guide Version
Table 6. Error messages and actions (continued)
Error code Error message
0B5A Unable to determine management IP address of this
node.
0B5B Unknown node type.
0B5C IP address conflict detected with the management IP.
There is a node that already has this IP address.
0B5E IP address conflict detected with its peer
management IP. There is a node that already has this
IP address.
0B5F Error updating node's data in newnodes.dat.
0B60 Error writing temporary file.
0B62 Node did not finish configuration before timeout.
0B7F All nodes must be up before adding a new node.
0B80 Unable to find the peer storage node.
0B81 The host name was not set properly.
0B82 Unable to create temp file nodes.lst.
0B85 Error copying cluster configuration to node.
0B86 Error restoring cluster configuration on node.
0B87 There was an error while adding nodes to the GPFS
cluster.
0B88 There was an error while configuring GPFS licensing. A
0B89 There was an error while configuring GPFS quorum.
0B8C There was an error in updating the configuration on
the new node.
0B8D Error reading checkpoint file.
0B8E Error writing to checkpoint file.
0B8F There was an error while installing GPFS callbacks.
0B92 Rsync failed between management nodes.
0B94 There were too many potential peer storage nodes.
Storage controllers may be cabled incorrectly or
UUIDs might not be set properly.
0B95 Invalid parameters.
0B96 Failed to configure the management processes on
mgmt001st001
0B97 IP is invalid.
0B98 Netmask is invalid.
Action key
A
B
D
D
B
A
B
A
Check Fibre Channel
cabling between the
file modules and the
control enclosure.
Verify that the control
enclosure is up. Refer
to "Powering the
system on and off" in
the IBM Storwize
V7000 Unified
Information Center.
A
A
A
A
A
A
A
A
A
A
C
A
D
D then A then B
D
D