IBM Storwize V7000 Unified Problem Determination Manual page 124

About this task
To install the DIMM air baffle, complete the following steps.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. Align the DIMM air baffle with the DIMMs and the back of the fans.
3. Lower the air baffle into place.
4. If necessary, replace PCI riser-card assembly 1, as described in "Installing a PCI
5. Install the cover, as described in "Installing the cover" on page 88.
6. Slide the file module into the rack.
7. Reconnect the external cables; then, reconnect the power cords and turn on the
Removing the fan bracket
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
100
Storwize V7000 Unified: Problem Determination Guide Version
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
riser-card assembly" on page 106.
file module.
Note: You must wait approximately 20 seconds after you connect the power
cord of the file module to an electrical outlet before the power-control button
becomes active.
Attention: For proper cooling and airflow, replace all air baffles before you
turn on the server. Operating the server with any air baffle removed might
damage server components.