IBM Storwize V7000 Unified Problem Determination Manual page 122

6. Install the cover, as described in "Installing the cover" on page 88.
7. Slide the file module into the rack.
8. Reconnect the external cables; then, reconnect the power cords and turn on the
Removing the DIMM air baffle
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
When you work with some optional devices, you must first remove the DIMM air
baffle to access certain components or connectors on the system board.
To remove the DIMM air baffle, complete the following steps.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
98
Storwize V7000 Unified: Problem Determination Guide Version
peripheral devices and the file module.
Note: You must wait approximately 2.5 minutes after you connect the power
cord of the file module to an electrical outlet before the power-control button
becomes active.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.