IBM Storwize V7000 Unified Problem Determination Manual page 130

2. Turn off the file module and peripheral devices, then label and disconnect both
3. Press down on the left and right side latches and pull the server out of the rack
4. Remove the cover, as described in "Removing the cover" on page 87.
5. Grasp the riser-card assembly at the front tab and rear edge and lift it to
Installing a PCI riser-card assembly
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
Before you begin
Ensure that you read and understand the following information:
v Standard models of the Storwize V7000 Unified come with one PCI riser-card
v A PCI riser-card assembly has a black connector and supports PCI adapters, and
v PCI riser slot 1 is the farthest slot from the power supplies. This slot supports
v PCI riser slot 2 is the closest slot to the power supplies. You must install a PCI
v Microprocessor 2, aux power, and PCI riser-card assembly 2 share the same
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
To install a riser-card assembly, complete the following procedure.
106
Storwize V7000 Unified: Problem Determination Guide Version
power cords and all external cables.
enclosure until both slide rails lock.
remove it from the file module. Place the riser-card assembly on a flat,
static-protective surface.
assembly installed. If you want to replace them with PCI-X riser-card assemblies,
you must order the PCI-X riser-card assembly option, which includes the
bracket.
a PCI-X riser-card assembly has a white (light in color) connector and supports
PCI-X adapters.
only low-profile adapters.
riser-card assembly in slot 2 even if you do not install an adapter.
power channel that is limited to 230 W.