IBM Storwize V7000 Unified Problem Determination Manual page 214

-mask
-serviceip_6
-gw_6
-default
-prefix_6
-resetpassword
Description
This command resets the service assistant IP address to the default value. If the
command is run on the upper canister, the default value is 192.168.70.121 subnet
mask: 255.255.255.0. If the command is run on the lower canister, the default value
is 192.168.70.122 subnet mask: 255.255.255.0. If the node canister is active in a
system, the superuser password for the system is reset; otherwise, the superuser
password is reset on the node canister.
If the node canister becomes active in a system, the superuser password is reset to
that of the system. You can configure the system to disable resetting the superuser
password. If you disable that function, this action fails.
This action calls the satask chserviceip command and the satask resetpassword
command.
Reset service assistant password command:
Use this command when you are unable to logon to the system because you have
forgotten the superuser password, and you wish to reset it.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
Parameters
None.
Description
This command resets the service assistant password to the default value passw0rd.
If the node canister is active in a system, the superuser password for the system is
reset; otherwise, the superuser password is reset on the node canister.
190
Storwize V7000 Unified: Problem Determination Guide Version
(Optional) The IPv4 subnet for the service assistant.
(Optional) The IPv6 address for the service assistant.
(Optional) The IPv6 gateway for the service assistant.
(Optional) Resets to the default IPv4 address.
(Optional) The IPv6 prefix for the service assistant.
(Optional) Sets the service assistant password to the default value.
satask resetpassword