Installing The Library Controller; Removing A Power Supply - IBM Universal Tape Library User Manual

1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the library and disconnect the power cord.
3. Disconnect the SCSI cable and Ethernet cable from the system control board.
4. Loosen the two captive screws.
5. Pull the library controller out of the library chassis as shown in Figure 19.
Figure 19. Removing the library controller

Installing the library controller

To install the library controller, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the library is turned off and that the power cord is disconnected.
3. Insert the library controller into the library chassis.
4. Tighten the captive screws.
5. Connect the Ethernet cable and the SCSI cable.
6. Turn on the library.
7. If you are not using DHCP, configure the Ethernet address. See "Network" on

Removing a power supply

To remove a power supply, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the library and disconnect the power cord.
3. Loosen the captive screw.
4. Pull the power supply out of the library chassis as shown in Figure 20 on page
on page 7.
on page 7.
page 22 for more information.
on page 7.
46.
Library
controller
Captive screws
Chapter 6. Removing and replacing library components
45