IBM Storwize V7000 Unified Problem Determination Manual page 126

7. Remove the DIMM air baffle, as described in "Removing the DIMM air baffle"
8. Press the fan-bracket release latches toward each other and lift the fan bracket
Installing the fan bracket
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
To install the fan bracket, complete the following procedure.
Procedure
102
Storwize V7000 Unified: Problem Determination Guide Version
on page 98.
out of the server.
1. To help you work safely with Storwize V7000 Unified file module, read the
safety information in "Safety" on page xi, "Safety statements" on page xiii,
and "Installation guidelines" on page 58.
2. Lower the fan bracket into the chassis.
3. Align the holes in the bottom of the bracket with the pins in the bottom of the
chassis.
4. Press the bracket into position until the fan-bracket release levers click into
place.
5. Replace the fans, as described in "Installing a hot-swap fan" on page 142.
6. Replace the PCI riser card assemblies, as described in "Installing a PCI
riser-card assembly" on page 106.