Installing The Ibm C-Type San Director Shelf Bracket Kit Into A Rack; Installing The Switch On The Brackets; Installing The Shelf Bracket Kit Into A Rack - IBM SAN192C-6 Installation, Service And User Manual

Installing the IBM c-type SAN Director Shelf Bracket Kit into a
Rack
About this task
Figure 23 shows the installation of the IBM c-type SAN Director Shelf Bracket Kit
into a four-post rack.
Figure 23. Installing the Shelf Bracket Kit into a Rack
Use this procedure to install the shelf brackets in a rack.
Procedure
1. Position a shelf bracket inside the rack-mounting rails. Align the screw holes at
2. Align the screw holes at the back of the shelf bracket with the holes in the back
3. Verify that the shelf brackets are at the same height (using the level or tape

Installing the Switch on the Brackets

This section provides information on how to install the switch on the rack-mount
support brackets and on the shelf brackets and includes the following subsections:
v "Installing the Switch on the Rack-Mount Support Brackets"
v "Installing the Switch on the Shelf Brackets" on page 47
Installing the Switch on the Rack-Mount Support Brackets
About this task
This topic provides general instructions for installing the switch on top of the
rack-mount support brackets.
46
SAN192C-6, SAN384C-6 and SAN768C-6 Installation, Service, and User Guide
the front of the shelf bracket with the holes in the front rack-mounting rail, and
then attach the shelf bracket to the front rack-mounting rail using a minimum
of three (M6, 12-32 or 12-24) screws.
rack-mounting rail, and then attach the shelf bracket to the back rack-mounting
rail using a minimum three (M6, 12-32 or 12-24) screws.
measure as desired).