IBM Storwize V7000 Unified Problem Determination Manual page 216

This command calls the satask installsoftware command.
Create cluster command:
Use this command to create a storage system.
Note: The reference to cluster is not the same as the file system cluster on the
Storwize V7000 file modules.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
Parameters
-clusterip
-gw
-mask
-clusterip_6
-gw_6
-prefix_6
-name
Description
This command creates a storage system.
This command calls the satask mkcluster command.
Query status command:
Use this command to determine the current service state of the node canister.
Syntax
192
Storwize V7000 Unified: Problem Determination Guide Version
satask mkcluster -clusterip
satask mkcluster -clusterip_6
(Optional) The IPv4 address for Ethernet port 1 on the system.
(Optional) The IPv4 gateway for Ethernet port 1 on the system.
(Optional) The IPv4 subnet for Ethernet port 1 on the system.
(Optional) The IPv6 address for Ethernet port 1 on the system.
(Optional) The IPv6 gateway for Ethernet port 1 on the system.
(Optional) The IPv6 prefix for Ethernet port 1 on the system.
(Optional) The name of the new system.
sainfo getstatus
ipv4
-gw ipv4 -mask
ipv6
-gw_6 ipv6 -prefix_6
ipv4 -name cluster_name
int -name cluster_name