IBM Storwize V7000 Unified Problem Determination Manual page 152

11. Select the management node with the bad hard disk drive.
12. If you are ready to replace the hard disk drive, respond yes to the prompts,
13. During the node shutdown period, replace the hard disk drive in slot 2 of the
14. Turn on the node by pressing the flashing power on/off button on the front of
15. After the node is restored, log in as root user on the node where the repair
Removing an optional ServeRAID adapter advanced feature key
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
Note: Before running a procedure, refer to "Removing a file module to perform a
maintenance action" on page 55.
Procedure
1. To help you work safely with Storwize V7000 Unified file module, read the
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover, as described in "Removing the cover" on page 87.
4. Grasp the feature key and lift to remove it from the connector on the
128
Storwize V7000 Unified: Problem Determination Guide Version
which shuts down the management node.
management node.
the node.
took place, and then run the df command from the command-line interface
(CLI). The /ftdc file system should now be mounted.
safety information in "Safety" on page xi, "Safety statements" on page xiii, and
"Installation guidelines" on page 58.
ServeRAID adapter. See Figure 28 on page 129 and Figure 29 on page 130.