Panasonic FP Series Programming Manual page 1312

Error Name
code
E100 Self- diagnostic
to error set by
E199 F148 (ERR)/
P148 (PERR)
E200
instruction
to
E299
40.9.3 Table of communication check error
Error Name
code
E63 PLC error mode
(Available PLC:
FP2/FP2SH/FP3/
FP10SH)
E64 No ROM/RAM error
(Available PLC:
FP2/FP2SH/FP3/
FP10SH)
E65 Protect error
E66 PLC write error
address error
(Available PLC:
FP2/FP2SH/FP3/
FP10SH)
E68 Rewrite during RUN
error
(Available PLC:
FP2/FP2SH/FP3/
FP10SH)
Operation Description and steps to take
status
Stops The self-diagnostic error specified by the F148 (ERR)/P148
(PERR) instruction is occurred.
Take steps to clear the error condition according to the
specification you chose.
Continues
Operation Description and steps to take
status
Stops Transfer was attempted in the RUN mode.
Switch the mode and execute once again.
Stops An abnormality occurred when loading RAM to ROM/IC
memory card. There may be a problem with the ROM or IC
memory card.
Check the contents of the ROM or IC memory card.
Stops Transfer was attempted during ROM operation or IC memory
card operation.
Switch the mode and execute once again.
Continues In the programming tool software, program editing is being
attempted by online access, but the program is not in
agreement. (The program disagreement lies in another
block.)Check the program.
Continues When inputting with the programming tool software, editing of
an instruction (ED, SUB, RET, INT, IRET, SSTP, and STPE)
that cannot perform a rewrite during RUN is being attempted.
Nothing is written to the CPU.
When loading, the specified contents exceeded the
-
capacity (256 KB).
Write error occurs.
-
ROM or IC memory card is not installed.
-
ROM or IC memory card does not conform to
-
specifications.
Appendix Programming Information
1311