Panasonic FP Series Programming Manual page 1289

Appendix Programming Information
No. Name
COM port 2 - sending end code/reception done condition
414
COM port 2 - receive buffer starting address
418
COM port 2 - receive buffer capacity
419
COM port 2 - modem connection
412
For PLC Link, the communication format and baud rate settings are fixed:
1)
Data length: 8 bits
Parity: Odd
Stop bit: 1 bit
End code:
Start code: No STX
Other system register settings will be ignored.
FPG-COM4: For RS485 connections (COM port 1), the baud rate must be set in the system registers and with
2)
the DIP switch.
40.8.4 System registers for FP0R
Memory size
No. Name
Sequence program area size
0
Depending on PLC type (12k, 16k, or 32k type)
1)
Hold on/off
1)
No Name
.
Counter start address
5
Timer/Counter hold area start address
6
Internal relay hold area start address (in word units)
7
Data register hold area start address
8
Link relay hold area start address for PLC Link 0 (in word units)
10
Link relay hold area start address for PLC Link 1 (in word units)
11
Link register hold area start address for PLC Link 0
12
Link register hold area start address for PLC Link 1
13
Step ladder hold/non-hold
14
FP0R-T32: If the battery is empty and additional hold areas have been defined, the hold/non-hold operation
1)
becomes unstable. The data value will become indefinite. It is cleared to 0 the next time the power is turned on.
Depending on PLC type (16k/32k type)
2)
Depending on PLC type (Fixed for C10, C14, C16, C32, variable for T32, F32)
3)
1288
CR
Default Values
CR CR/CR+LF/ETX/Non
e
2048 0–32762
0 0–2048
Disable Disable/Enable
Default Values
Fixed
12/16/32 kwords
1)
Default Values
1008 0–1024
1008
Fixed/0–1024
248
Fixed/0–256
12000/
Fixed/0–32763
32450
2)
64
Fixed/0–64
128
Fixed/64–128
128
Fixed/0–128
256
Fixed/128–256
Non-hold Fixed or
Hold/Non-hold3)
3)
3)
3)
3)
3)
3)
3)