Delete Additive Offsets (Deldl) - Siemens SINUMERIK 840D sl Programming Manual

Tool offsets
7.2 Additive offsets
7.2.3

Delete additive offsets (DELDL)

Function
The DELDL command deletes the additive offsets for the cutting edge of a tool (to release
memory space). Both the defined wear values and the setup values are deleted.
Syntax
DELDL[<t>,<d>]
DELDL[<t>]
DELDL
<Status>=DELDL[<t>,<d>]
Significance
DELDL
<t>
<d>
DELDL[<t>,<d>]
DELDL[<t>]
DELDL
<status>
Note
Wear and setting-up values of active tools cannot be deleted (essentially the same as the
delete behavior of D or tool data).
454
Command to delete additive offsets
T number of the tool
D number of the tool cutting edge
All additive offsets of the cutting edges <d> of the tool <t> are
deleted.
All additive offsets of all cutting edges of tool <t> are deleted.
All additive offsets of all cutting edges of all tools of the TO unit are
deleted (for the channel in which the command is programmed).
Delete status
Value: Significance:
0 Deletion was successfully completed.
- Offsets have not been deleted (if the parameter settings
specify exactly one tool edge), or not deleted completely (if
the parameter settings specify several cutting edges).
Programming Manual, 06/2009, 6FC5398-2BP20-0BA0
Job Planning