Keysight X Series Measurement Manual page 73

Concepts
MSR Measurement Concepts
The following SCPI commands in the LTE TDD Conformance EVM
measurement are not available in this measurement.
SCPI Command not available in this Measurement
:DISPlay:CEVM:VIEW1|VIEW[:SELect]
[:SENSe]:CEVM:AVERage:NUMber
[:SENSe]:CEVM:AVERage:TCONtrol
[:SENSe]:CEVM:DLINk:DECode:DFINclude
[:SENSe]:CEVM:DLINk:DECode:RNTI:MAXimum:RA
[:SENSe]:CEVM:DLINk:DECode:RNTI:MAXimum:TPC
[:SENSe]:CEVM:DLINk:DECode:RNTI:MINimum:RA
[:SENSe]:CEVM:DLINk:DECode:RNTI:MINimum:TPC
[:SENSe]:CEVM:DLINk:RESult
[:SENSe]:CEVM:EVM:COPY[:IMMediate]/nquery/
[:SENSe]:CEVM:METHod
[:SENSe]:CEVM:ULINk:DECode:PUSCh
[:SENSe]:CEVM:ULINk:RESult
W-CDMA Format Parameter List
Since most parameters are the same as those used in the original
measurement, the SCPI commands in the original measurement can be used in
this measurement by converting the measurement node.
The following SCPI commands in the W-CDMA application are converted for
this measurement as follows:
Parameter Name SCPI Command in W-CDMA mode
HSPA Enable [:SENSe]:RADio:CONFigure:EHSPa[:STAT
e]
HSPA+ Enable [:SENSe]:RADio:CONFigure:HSDPa[:STA
Te]
The following SCPI commands in the W-CDMA Mod Accuracy measurement
are converted for this measurement as follows:
SCPI Command in Mod Accuracy
[:SENSe]:RHO:AVERage:COUNt
[:SENSe]:RHO:AVERage[:STATe]
Keysight N9083A & W9083A Measurement Guide
SCPI Command in W-CDMA Format Parameter List
[:SENSe]:RADio:FORMat:WCDMa{1:3}:CONFigure:EHS
Pa[:STATe]
[:SENSe]:RADio:FORMat:WCDMa{1:3}:CONFigure:HS
DPa[:STATe]
SCPI Command in this measurement
[:SENSe]:CEVM:WCDMa:AVERage:COUNt
[:SENSe]:CEVM:WCDMa:AVERage[:STATe]
73