Making Msr Measurements - Keysight X Series Measurement Manual

Keysight X-Series Signal Analyzers
N9083A & W9083A
Multi-Standard Radio Measurement Application Measurement Guide
2

Making MSR Measurements

This chapter begins with instructions common to all measurements including
equipment configuration, simple steps for making a measurement, then details
how to make the measurements available by pressing the MSR mode and
Meas key for MSR Downlink signal.
Currently only BTS is supported for Radio Device in MSR mode, so all the
measurement examples are based on MSR downlink signals.
•
•
"Setting Up and Making a Measurement" on page 10
"MSR Downlink Signal Measurement" on page 12
- "Configuring the Measurement System" on page 12
- "Setting the Downlink Signal" on page 14
- "Common Measurement Procedure (Downlink)" on page 16
- "Monitor Spectrum Measurements" on page 17
- "IQ Waveform (Time Domain) Measurements" on page 20
- "Channel Power Measurements" on page 23
- "Occupied Bandwidth Measurements" on page 26
- "ACP Measurements" on page 28
- "Spurious Emissions Measurement" on page 35
- "Spectrum Emission Mask Measurements" on page 31
- "Power Statistics CCDF Measurements" on page 38
- "Conformance EVM Measurement" on page 41
9