About The Msr Measurement Application - Keysight X Series Measurement Manual

Keysight X-Series Signal Analyzers
N9083A & W9083A
Multi-Standard Radio Measurement Application Measurement Guide
1

About the MSR Measurement Application

This chapter provides overall information on MSR (Multi-Standard Radio)
communications systems, and describes MSR measurements made by the
analyzer.
What Does the MSR Application Do?
This analyzer can be used for testing a MSR downlink signal in base station
continuous spectrum operation or non-contiguous operation complying with
the standards listed below. Because they are continually changed, each release
will support the most recent version of these standards:
— 3GPP TS 37.141 v.10.6.0 (2012-03) E-UTRA, UTRA and GSM/EDGE;
— 3GPP TS 37.104 V9.4.0 (2010-12) E-UTRA, UTRA and GSM/EDGE;
The instrument automatically makes these measurements using the
measurement methods and limits defined in the documents. The detailed
results displayed by the measurements enable you to analyze MSR signals
performance. You may alter the measurement parameters for specific analysis.
This analyzer makes the following measurements providing power
measurements and modulation analysis for the MSR signals:
— Channel Power
— Occupied BW
— Adjacent Channel Power (ACP)
— Spectrum Emission Mask
— Spurious Emissions
— MSR Conformance EVM
— Power Stat CCDF
— Monitor Spectrum
— IQ Waveform (Time Domain)
The following description are the guidelines for this application.
Multi-Standard Radio (MSR) Base Station (BS) conformance testing
(Release 10)
Multi-Standard Radio (MSR) Base Station (BS) transmission and reception
(Release 9)
7