Keysight X Series Measurement Manual page 21

Making MSR Measurements
MSR Downlink Signal Measurement
Step
3. Adjust the scale.
4. Select the IQ
Waveform view.
Figure 2-8 MSR Downlink Waveform Measurement - I/Q Waveform View
5. Turn on Marker
functions.
6. (Optional) Change
measurement
parameters from their
default condition.
If you have a problem, and get an error message, see the guide "Instrument
Messages", which is provided on the Documentation CD ROM, and in the
instrument here:
Keysight N9083A & W9083A Measurement Guide
Action
AMPTD Y Scale
Press the
SPAN X Scale and configure the setup
until the waveforms are shown at a
convenient voltage scale for viewing.
View/Display, IQ
Press
Waveform
.
Maker Function
Press the
use Maker Noise, Band/Interval Power,
Band/Interval Density and Marker
Function Off. You can use Band Adjust
to set the frequency span for analysis.
Meas Setup
Press the key to see the
keys available to change.
Notes
and
The IQ Waveform window provides a view of
the I (yellow trace) and Q (blue trace)
waveforms on the same graph in terms of
voltage versus time in linear scale
key to
21