Setting The Downlink Signal - Keysight X Series Measurement Manual

Making MSR Measurements
MSR Downlink Signal Measurement

Setting the Downlink Signal

In this example, the test signal is created according to MSR test configuration
TC4c of standard 3GPP TS 37.141. Keysight Signal Studio N7624B, is used to
generate the MSR waveform for testing.
Figure 2-3 MSR Downlink Signal - Example of TC4c
14
E-UTRA Band: 8
Operation Band (RF bandwidth): 925 MHz - 960 MHz
Output Power: –10 dBm
Carriers: 6
The carriers are placed using TC4c generation and test
models in 3GPP TS 37.141: a GSM carrier at the high
end and a GSM carrier at the low end of the RF
bandwidth, two W-CDMA carriers and two 5 MHz LTE
FDD carriers in the middle of the RF bandwidth. GSM
carriers are configured according to the definition in
3GPP TS 51.021 subclause 6.2.2, W-CDMA carriers are
configured according to TM1 in 3GPP TS 25.141
subclause 6.1.1.1, LTE FDD carriers are configured
according to E-TM1 in 3GPP TS 36.141 subclause
6.1.1.1.
Keysight N9083A & W9083A Measurement Guide