Keysight X Series Measurement Manual page 72

Concepts
MSR Measurement Concepts
[:SENSe]:CEVM:ULINk:BERate:DECoder:ITERation
[:SENSe]:CEVM:ULINk:BERate:DECoder[:STATe]
[:SENSe]:CEVM:ULINk:BERate:PRBS:SYNC:AUTO
[:SENSe]:CEVM:ULINk:BERate:PRBS:SYNC:INITial
[:SENSe]:CEVM:ULINk:BERate:PRBS[:TYPE]
[:SENSe]:CEVM:ULINk:BERate:RESult
[:SENSe]:CEVM:ULINk:BERate:RESYnc:LENGth
[:SENSe]:CEVM:ULINk:BERate:RESYnc:MODE
[:SENSe]:CEVM:ULINk:BERate[:STATe]
[:SENSe]:CEVM:ULINk:BERate:SYNC:AUTO
[:SENSe]:CEVM:ULINk:BERate:SYNC:FOFFset
[:SENSe]:CEVM:ULINk:BERate:SYNC:LOCation
[:SENSe]:CEVM:ULINk:DECode:PUSCh
[:SENSe]:CEVM:ULINk:RESult
LTE TDD Format Parameter List
Since most parameters are the same as those used in the original
measurement, the SCPI commands in the original measurement can be used in
this measurement by converting the measurement node.
The following SCPI commands in the LTE FDD Conformance EVM
measurement are converted for this measurement as follows:
SCPI Command in LTE TDD CEVM
[:SENSe]:CEVM:AVERage:COUNt
[:SENSe]:CEVM:AVERage[:STATe]
These commands above are not in the Format Parameter List.
The preset of the following command differs between the LTE TDD CEVM and
MSR CEVM.
SCPI Command in LTE TDD CEVM
[:SENSe]:CEVM:MCFilter:STATe
72
SCPI Command in this measurement
[:SENSe]:CEVM:LTETdd:AVERage:COUNt
[:SENSe]:CEVM:LTETdd:AVERage[:STATe]
SCPI Command in this measurement
[:SENSe]:RADio:FORMat:LTETdd{1:3}:MCFilter:STATe
Keysight N9083A & W9083A Measurement Guide
Preset in this
measurement
1