Keysight X Series Measurement Manual page 81

Concepts
MSR Measurement Concepts
:DISPlay:EEVM:VIEW2:WINDow3:TRACe:Y[:SCALe]:RPOSition
[:SENSe]:EEVM:AVERage:TCONtrol
[:SENSe]:EEVM:AVERage:TYPE
cdma2000 Format Parameter List
Since most parameters are the same as those used in the original
measurement, the SCPI commands in the original measurement can be used in
this measurement by converting the measurement node.
The following SCPI commands in the cdma2000 Mod Accuracy measurement
are converted for this measurement as follows:
SCPI Command in Mod Accurracy
[:SENSe]:RHO:AVERage:COUNt
[:SENSe]:RHO:AVERage[:STATe]
[:SENSe]:RHO:SPECtrum
These commands above are not in the Format Parameter List.
The following SCPI commands in the cdma2000 Mod Accuracy are not
available in this measurement.
SCPI Command not available in this measurement
:CALCulate:RHO:DTXBurst
:CALCulate:RHO:LIMit:CDERror
:CALCulate:RHO:LIMit:PEAK
:CALCulate:RHO:LIMit:PHASe
:CALCulate:RHO:LIMit:RHO
:CALCulate:RHO:LIMit:RMS
:CALCulate:RHO:LIMit:TIMing
:CALCulate:RHO:MARKer{1:12}:AOFF/nquery/
:CALCulate:RHO:MARKer{1:12}:CHIP
:CALCulate:RHO:MARKer{1:12}:COUPle[:STATe]
:CALCulate:RHO:MARKer{1:12}:CPEak[:STATe]
:CALCulate:RHO:MARKer{1:12}:FUNCtion:RESult?/qonly/
:CALCulate:RHO:MARKer{1:12}:MAXimum/nquery/
:CALCulate:RHO:MARKer{1:12}:MAXimum:HIGHer/nquery/
Keysight N9083A & W9083A Measurement Guide
SCPI Command in this measurement
[:SENSe]:CEVM:CDMA:AVERage:COUNt
[:SENSe]:CEVM:CDMA:AVERage[:STATe]
[:SENSe]:CEVM:SPECtrum
81