Table of Contents
Advertisement
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
WARNING: To reduce the risk of fire or burns after removing the energy pack:
•
Do not disassemble, crush, or puncture the energy pack.
•
Do not short external contacts.
•
Do not dispose of the energy pack in fire or water.
After power is disconnected, battery voltage might still be present for 1s to 160s.
CAUTION: Protect the server from power fluctuations and temporary interruptions with a regulating UPS. This
device protects the hardware from damage caused by power surges and voltage spikes and keeps the server in
operation during a power failure.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
CAUTION: To avoid data loss, Hewlett Packard Enterprise recommends that you back up all server data before
installing or removing a hardware option, or performing a server maintenance or troubleshooting procedure.
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating the server
in this manner results in improper airflow and improper cooling that can lead to thermal damage.
Rack warnings and cautions
WARNING: When all components are removed, the server weighs 6.12 kg (13.49 lb). When all components are
installed, the server can weigh up to 17.60 kg (38.80 lb).
Before configuring your rack solution, be sure to check the rack manufacturer weight limits and specifications.
Failure to do so can result in physical injury or damage to the equipment and the facility.
WARNING: The server is heavy. To reduce the risk of personal injury or damage to the equipment, do the following:
•
Observe local occupational health and safety requirements and guidelines for manual material handling.
•
Get help to lift and stabilize the product during installation or removal, especially when the product is not
fastened to the rails. The server weighs more than 6.12 kg (13.49 lb), so at least two people must lift the server
into the rack together. An additional person may be required to help align the server if the server is installed
higher than chest level.
•
Use caution when installing the server in or removing the server from the rack.
•
Adequately stabilized the rack before extending a component outside the rack. Extend only one component at a
time. A rack may become unstable if more than one component is extended.
•
Do not stack anything on top of rail-mounted component or use it as a work surface when extended from the
rack.
39
Setup
Advertisement
Table of Contents
