Table of Contents
Advertisement
a. Insert the SSD into the M.2 SSD slot at a 45° angle.
b. Carefully press the SSD down to the horizontal position.
c. Secure the SSD to the M.2 SSD enablement board with the removed Phillips screw.
11. If removed, install the air baffle.
12. Install the access panel.
13. Install the front bezel.
14. Do one of the following:
If the server is in tower mode: Position the tower server for operation.
•
•
If the server is in rack mode: Install the server on the tray.
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server.
The installation is complete.
Installing an M.2 NVMe SSD on an M.2 SSD/dedicated iLO/serial port enablement board
Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
•
T-15 Torx screwdriver
•
4.5 mm hex nut screwdriver
•
Phillips No. 1 screwdriver
Hardware options installation
79
Advertisement
Table of Contents
