Table of Contents
Advertisement
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
•
If the server is in rack mode: Remove the server from the rack.
•
5. Remove the front bezel.
6. Remove the access panel.
7. Remove the air baffle:
a. Lift the front end of the baffle from the chassis.
b. Remove the baffle from the slots on the rear chassis.
Install the air baffle
CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
Procedure
1. Install the air baffle:
a. Insert the tabs on the baffle into the slots on the rear chassis.
b. Press the front end of the baffle into the chassis.
29
Operations
Advertisement
Table of Contents
