Table of Contents
Advertisement
•
System ROM
•
Storage controller
•
Network adapters
•
Intelligent Provisioning
Set up the storage
7. Set up the storage. Do one of the following:
•
To configure the server to boot from a SAN, see the following guide:
https://www.hpe.com/info/boot-from-san-config-guide
•
If an HPE Smart Array SR controller is installed, use the HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run HPE Smart Storage Administrator.
•
If no controller option is installed, do one of the following:
◦
AHCI is enabled by default. You can deploy an OS or virtualization software.
◦
Disable AHCI, enable software RAID, and then create an array:
a. From the boot screen, press F9 to run UEFI System Utilities.
b. From the UEFI System Utilities screen, select System Configurations > BIOS/Platform Configuration
(RBSU) > Storage Options > SATA Controller Options > Embedded SATA Configuration > Smart Array
SW RAID Support.
c. Enable Smart Array SW RAID Support.
d. Save the configuration and reboot the server.
e. Create an array:
I.
II.
Deploy an OS or virtualization software
8. Deploy an OS or virtualization software. Do one of the following:
Press F10 at the POST screen.
•
For Intelligent Provisioning 3.30 and later, you are prompted to select whether you want to enter the Intelligent
Provisioning or HPE Rapid Setup Software mode. After you have selected a mode, you must reprovision the server
to change the mode that launches when you boot to F10.
•
Manually deploy an OS:
a. Insert the installation media.
36
Setup
From the boot screen, press F9 to run UEFI System Utilities.
From the UEFI System Utilities screen, select System Configuration > Embedded Storage: HPE
Smart Storage S100i SR Gen10 > Array Configuration > Create Array.
Advertisement
Table of Contents
