Table of Contents
Advertisement
If the server is in tower mode: Position the tower server for hardware configuration.
•
If the server is in rack mode: Remove the server from the rack.
•
5.
Remove the front bezel.
6.
Remove the access panel.
7.
If installed, remove the air baffle.
8.
Remove the alignment screws:
•
If installing an M.2 2242 or 2280 SSD, remove both the hex nut and Phillips screw.
•
If installing the M.2 22110, remove only the Phillips screw. Retain the hex nut.
9.
Install the hex nut screw on 2242 or 2280 standoff position on the system board.
10. Install the M.2 SSD:
78
Hardware options installation
Advertisement
Table of Contents
