Table of Contents
Advertisement
Prerequisites
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
Procedure
1.
Power down the server.
2.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Disconnect all peripheral cables from the server.
4.
Do one of the following:
•
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack.
•
5.
Remove the front bezel.
6.
Remove the access panel.
7.
Install the PCI fan option:
a. Mount the fan on the chassis.
b. Verify that the guiding pins on the fan guard are inserted into the chassis opening.
c. Secure the fan with the screws.
d. Connect the fan cable.
8.
Install the air baffle:
a. Insert the tabs on the baffle into the slots on the rear chassis.
b. Press the front end of the baffle into the chassis.
48
Hardware options installation
Advertisement
Table of Contents
