Cb (Commissioning Pushbutton); Nr (Network Reset); Operational Network Parameters Commands - Digi XBee 3 ZigBee User Manual

AT commands
Default
0x00

CB (Commissioning Pushbutton)

Use CB to simulate Commissioning Pushbutton presses in software.
You can issue CB even if the Commissioning Button functionality is disabled (D0 is not set to 1).
Set the parameter value to the number of button presses that you want to simulate. For example,
send CB1 to perform the action of pressing the Commissioning Pushbutton once.
Parameter range
1, 2, 4
Parameter
1
2
4
Default
N/A

NR (Network Reset)

Resets network layer parameters on one or more modules within a PAN. Responds immediately with
an OK then causes a network restart. The device loses all network configuration and routing
information.
If NR = 0: Resets network layer parameters on the node issuing the command.
If NR = 1: Sends broadcast transmission to reset network layer parameters on all nodes in the PAN.
Note NR and NR0 both perform the same function and may be used interchangeably.
Parameter range
0 - 1
Default
N/A

Operational Network Parameters commands

The following read-only AT commands provide information about the attached Zigbee network.
Digi XBee® 3 Zigbee® RF Module
Description
If disassociated:
Join Network.
n
If associated:
Wake device for 30 seconds, if sleeping.
n
Send Node Identification broadcast.
n
Enable joining for 1 minute (or NJ seconds if NJ is not 0 or 0xFF).
Restore device configuration to default and leave the network.
Operational Network Parameters commands
183