Digi XBee 3 ZigBee User Manual page 308

Status Transparent
code mode string Description
Reject ID Not an association candidate because
0x06
configured pan ID does not match that given
in the beacon response.
Reject NJ
0x07 Not an association candidate because it is not
allowing joins.
JV/NW with search option (DO80) has found a
0x08 panID Match
matching network.
Reject JV/NW with search option (DO80) candidate
0x09
LQIRSSI rejected because this beacon response is
weaker than an earlier beacon response.
0x0A Beacon Saved This beacon response is a suitable candidate
for an association request.
AI AI value has changed.
0x0B
NJ setting (Permit Join Duration) has changed value(1)
0x0C Permit Join
0x0D Scanning Active scanning has begun.
0x0E Scan Error An error occurred during active scan.
Status data Description
panId(2) 16 bit PAN Identifier for network
radioChannel channel number ranging from 11 to 26 (0x0B to 0x1A)
(1)
radioTxPower low level signed byte value for transmit power, values range
(1) from 0xC9 to 0x05 inclusive
panid(2) 16 bit PAN Identifier for network
extendedPanId 64 bit PAN Identifier for network
(8)
See a description of
AIStatusCode
(1)
See a description of the
A 32 bit value driven by the SC setting where bit positions 11
ChannelMask
through 26 show which channels are enabled for the
(4)
upcoming Active Scan. See a description of
Channels).
StatusCode(1)
AI (Association Indication)
NJ (Node Join Time) command.
SC (Scan