AT commands
Parameter
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Default
1
SI (Sleep Immediately)
Executable command. Causes a cyclic sleep device to sleep immediately rather than wait for the ST
timer to expire.
Note
If you issue this command in Command mode, the module remains in Command mode until the
CT timer expires or you issue a CN command.
Parameter
N/A
Default
N/A
I/O settings commands
The following commands configure the various I/O lines available on the XBee 3 Zigbee RF Module.
D0 (DIO0/AD0/Commissioning Button Configuration)
Sets or displays the DIO0/AD0/CB configuration (Micro pin 31/SMT pin 33/TH pin 20).
Digi XBee® 3 Zigbee® RF Module
Child table timeout
10 seconds
2 minutes
4 minutes
8 minutes
16 minutes
32 minutes
64 minutes
128 minutes
256 minutes
512 minutes
1024 minutes
2048 minutes
4096 minutes
8192 minutes
16384 minutes
I/O settings commands
214