Oi (Operating 16-Bit Pan Id); Operating Channel); Nc (Number Of Remaining Children); Security Commands - Digi XBee 3 ZigBee User Manual

AT commands

OI (Operating 16-bit PAN ID)

Read the 16-bit PAN ID of the attached network. The OI value reflects the actual 16-bit PAN ID where
the device is running.
Parameter range
0 - 0xFFFF [read-only}
Default
N/A
CH (Operating Channel)
Read the channel number of the attached network. Channels are represented as IEEE 802.15.4
channel numbers.
A value of 0 means the device has not joined a PAN and is not operating on any channel.
Parameter range
0, 0x0B - 0x1A (Channels 11 through 26) [read-only]
Default
N/A

NC (Number of Remaining Children)

Read the number of remaining end device children that can join the device. If NC returns 0, the device
is at capacity and cannot allow any more end device children to join.
Parameter range
0 - 0x14 (20 child devices)
Default
N/A

Security commands

The following AT commands are used to set the initial security parameters.
Note Configure these parameters prior to forming/joining a network. Changing these parameters
may cause the node to leave any currently attached network.

EE (Encryption Enable)

Set or read the encryption enable setting of the local device.
Parameter range
0 - 1
Digi XBee® 3 Zigbee® RF Module
Security commands
185