I/O Settings Commands; Cb (Commissioning Pushbutton); D0 (Dio0/Ad0); D1 (Dio1/Ad1) - Digi XBee DigiMesh 2.4 User Manual

AT commands

I/O settings commands

The following AT commands are I/O settings commands.

CB (Commissioning Pushbutton)

Use CB to simulate commissioning pushbutton presses in software.
Set the parameter value to the number of button presses that you want to simulate. For example,
send CB1 to perform the action of pressing the Commissioning Pushbutton once.
Parameter range
0 - 4
Default
N/A

D0 (DIO0/AD0)

Sets or displays the DIO0/AD0 configuration (pin 20).
Parameter range
0 - 5
Parameter
0
1
2
3
4
5
Default
1

D1 (DIO1/AD1)

Sets or displays the DIO1/AD1 configuration (pin 19).
Parameter range
0, 2 - 5
Parameter
0
XBee/XBee-PRO DigiMesh 2.4 RF Module User Guide
Description
Disabled
Commissioning Pushbutton
ADC
Digital input
Digital output, low
Digital output, high
Description
Disabled

I/O settings commands

88