Se (Source Endpoint); Destination Endpoint) - Digi XBee 3 ZigBee User Manual

AT commands
When operating in API mode, if the Transmit Options field in the API frame is 0, the TO parameter
value will be used instead.
Parameter range
0 - 0xFF
Bit field:
Unused bits must be set to 0. These bits may be logically ORed together:
Bit Meaning
0 Disabled retries and route repair.
4 Secure Session. Send data securely—requires secure session.
Enable APS end-to-end encryption (if EE = 1).
5
6 Use extended timeout.
Default
0

SE (Source Endpoint)

Sets or displays the application layer source endpoint value used for data transmissions.
This command only affects outgoing transmissions in Transparent mode (AP = 0).
Note Endpoints 0xDC - 0xEE are reserved for special use by Digi and should not be used in an
application outside of the listed purpose. The reserved Digi endpoints are:
0xE8 - Digi data endpoint
n
0xE6 - Digi device object endpoint
n
0xE5 - Secure Session Server endpoint
n
0xE4 - Secure Session Client endpoint
n
0xE3 - Secure Session SRP authentication endpoint
n
Parameter range
0 - 0xFF
Default
0xE8
DE (Destination Endpoint)
Sets or displays the application layer destination endpoint used for data transmissions.
This command only affects outgoing transmissions in Transparent mode (AP = 0).
Note Endpoints 0xDC - 0xEE are reserved for special use by Digi and should not be used in an
application outside of the listed purpose. The reserved Digi endpoints are:
Digi XBee® 3 Zigbee® RF Module
Zigbee addressing commands
195