Bt (Bluetooth Enable); Bi (Bluetooth Identifier); S (Srp Salt) - Digi XBee 3 ZigBee User Manual

AT commands
Parameter range
N/A
Default
N/A

BT (Bluetooth Enable)

BT enables or disables the Bluetooth functionality.
Note When Bluetooth is enabled, the XBee 3 Zigbee RF Module cannot be in Sleep mode. If the device
is configured to allow Sleep mode and you enable Bluetooth, the XBee 3 Zigbee RF Module will not
enter sleep.
Parameter range
Bit Description
0 Bluetooth functionality is disabled.
1 Bluetooth functionality is enabled.
Default
0

BI (Bluetooth Identifier)

A human-friendly name for the device. This is the name that will appear in bluetooth advertisement
messages.
If set to default (ASCII space character), the bluetooth indicator will display as XBee3 Zigbee.
If using XBee Mobile, adjustments to the filter options will be needed if this value is populated.
Parameter range
A string of case-sensitive ASCII printable characters from 1 to 22 bytes in length.
Default
0x20 (an ASCII space character)

$S (SRP Salt)

Note You should only use this command if you have already
and the salt corresponds to the password.
The Secure Remote Password (SRP) Salt is a 32-bit number used to create an encrypted password for
the XBee 3 Zigbee RF Module. Use the $S command in conjunction with the $V, $W, $X, and $Y
verifiers. Together, the command and the verifiers authenticate the client for the BLE API Service
without storing the XBee password on the XBee 3 Zigbee RF Module.
Configure the salt in the $S command. In the $V, $W, $X, and $Y verifiers, you specify the 128-byte
verifier value, where each command represents 32 bytes of the total 128-byte verifier value.
Digi XBee® 3 Zigbee® RF Module
configured a password on the XBee device
BLE commands
210