Secure Transmission Failures; Data Frames - 0X10 And 0X11 Frames; Remote At Commands- 0X17 Frames - Digi XBee 3 ZigBee User Manual

Secure access

Secure transmission failures

This section describes the error messages you can see when trying to send a secure packet.

Data Frames - 0x10 and 0x11 frames

Response frame type:
n
Possible error statuses:
Status Description
0x34 No Secure
Session
Connection
0x35 Encryption
Failure

Remote AT Commands- 0x17 frames

Response frame type:
n
Possible error statuses:
Status Description
0x0B No Secure Session
Connection
0x0C Encryption Error
0x0D TO Bit Not Set
Digi XBee® 3 Zigbee® RF Module
Transmit Status frame - 0x8B
Reason
The sending node does not have an active session with the destination
node.
The encryption process failed. Only likely to be seen when using manual
SRP and when an invalid encryption parameter was passed in.
Remote Command Response frame - 0x97
Reason
The sending node does not have an active session with the
destination node.
There was an internal encryption error on the radio.
The client has a session with the server but forgot to set the TO
bit.
Secure transmission failures
47