W4: Grinding-Specific Tool Offset And Tool Monitoring; Grinding-Specific Tool Data; Structure Of Tool Data - Siemens SINUMERIK 840D sl Function Manual

W4: Grinding-specific tool offset and tool monitoring

18.1

Grinding-specific tool data

18.1.1

Structure of tool data

Grinding tools (tool type: 400 to 499) normally have specific tool and dresser data in addition
to cutting edge data.
The grinding wheel-specific data for the left and right wheel geometry can be stored under a
T number in the tool cutting edges D1 and D2.
If data is needed for the dresser geometry, it can be stored as follows:
● In the tool cutting edges from D3 of a T number
● In additional cutting edge-specific parameters (see MD18096
$MN_MM_NUM_CC_TOA_PARAM)
<t>:
<d>:
The following figure provides an overview of the (possible) storage structure of the tool data
for grinding tools:
Extended Functions
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
T number
D number
18
843