Parameterization - Siemens SINUMERIK 840D sl Function Manual

H1: Manual and handwheel travel
4.9 Approaching a fixed point in JOG
"JOG: position reached <axis>"
To withdraw from the fixed position, you must deactivate the "Approaching fixed point in JOG"
function.
Special features of incremental travel
If, during incremental travel, the fixed point is reached before the increment is completed, then
the increment is considered to have been completed fully. This is the case even when only
whole increments are traveled.
MD11346 $MN_HANDWH_TRUE_DISTANCE = 2 or 3
Special features of modulo rotary axes
Modulo rotary axes can approach the fixed point in both directions. The shortest path (DC) is
not observed during the travel.
Features of spindles
A spindle changes to the positioning mode on actuating the "Approaching fixed point in JOG"
function. The closed loop position control is active and the axis can traverse to the fixed point.
If no zero mark is detected the alarm message in the axis operation is output:
Alarm 17810 "Channel %1 Axis %2 not referenced"
As a spindle must also be a modulo rotary axis at all times, the same conditions apply for
direction observation as for modulo rotary axes (refer to the paragraph "Features of modulo
rotary axes")
4.9.2

Parameterization

Movement in the opposite direction
The behavior while traversing in the opposite direction - i.e. in the direction opposite to
approaching the fixed point - depends on the following setting:
MD10735 $MN_JOG_MODE_MASK, bit 2 (settings for the JOG mode)
Bit
2
Fixed point positions
Up to four fixed point positions can be defined for an axis:
MD30600 $MA_FIX_POINT_POS[0...3] = <fixed point position 1...4>
188
Value Meaning
0 Travel in the opposite direction is not possible (default setting).
1 Movement in the opposite direction is possible.
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
Extended Functions