Siemens SINUMERIK 840D sl Function Manual page 152

H1: Manual and handwheel travel
4.3 Parameter assignment (general)
SD41100 $SN_JOG_REV_IS_ACTIVE (JOG: revolutional/linear feedrate)
Bit
0
1
2
3
Note
If a master spindle has not been defined and the axis is to be manually traversed at a
revolutional feedrate, alarm 20055 is output or alarm 20065 for geometry axes.
Velocity
The system data that determines the speed of the manual traversing is dependent upon the
active feedrate behavior.
152
Value Meaning
0 The behavior of the axis/spindle depends on the setting data:
SD43300 $SA_ASSIGN_FEED_PER_REV_SOURCE (revolutional feedrate for
positioning axes/spindles)
The behavior of a geometry axis on which a frame with rotation acts, or of an
orientation axis, depends on the channel-specific setting data:
SD42600 $SC_JOG_FEED_PER_REV_SOURCE (control of the revolutional fee‐
drate in JOG)
1 For a JOG movement, it is always traversed with revolutional feedrate as a function
of the master spindle.
0 For rapid traverse as well, the axis/spindle, geometry axis or orientation axis is
traversed with revolutional feedrate (selection see Bit 0).
1 For rapid traverse, the axis/spindle, geometry axis or orientation axis is always
traversed without revolutional feedrate.
0 For JOG handwheel traverse as well, the axis/spindle, geometry axis or orientation
axis is traversed with revolutional feedrate (selection see Bit 0).
1 For JOG handwheel traverse, the axis/spindle, geometry axis or orientation axis
is always traversed without revolutional feedrate.
0 For DRF handwheel traverse as well, the axis/spindle is traversed with revolutional
feedrate (selection see Bit 0).
1 For DRF handwheel traverse, the axis/spindle is always traversed without revolu‐
tional feedrate.
Function Manual, 10/2015, 6FC5397-1BP40-5BA3
Extended Functions