Network Setup And Configuration - Graco 25A693 Instructions Manual

Network Setup and Configuration

Network Setup Setup and
Network Network Setup
Use these procedures to configure network settings
that determine how the Intelligent Paint Kitchen
components communicate with each other.
Configure the the Display Display
Configure Configure the Display
Use this procedure to enter the network settings that
allow the Touchscreen Module (14) to communicate
with the Intelligent Paint Kitchen components.
1. Press on any Run screen.
2. On the Setup Menu screen, press HMI
Configuration. Configuration Configuration
3. On the Display Configuration screen, press Port
1 1 1 . Port 1 is used to communicate with external
Ethernet networks. Configure Port 1 if you want
remote access or email.
4. On the read-only Network Configuration screen,
Edit Config Config.
press Edit Edit Config
5. On the editable Network Configuration screen,
press the data fields to be changed. Use the
popup screen to enter the network setting.
Repeat as needed until all the Network
Configuration settings are correct.
Field Field Field
Port Mode
IP Address
Subnet Mask
Gateway
DNS1
DNS2
MAC ID
6. Press Apply Apply to enter the changes and have them Apply
take effect . The Network Configuration screen
appears again, showing the updated settings.
92
and Configuration Configuration
and Configuration
HMI
HMI
Port Port
Value Value Value
Manual or DHCP
IP address provided
by your IT team to
connect to your facility
network (for example,
10.20.156.34)
Subnet mask that
matches your network
settings
Gateway that matches
your network settings
Your DNS1 setting
Your DNS2 setting
MAC ID of your device
7. On the Display Configuration screen, press
Port Port 2 2 2 . Port 2 is used to communicate to the Port
Supervisor Module using Modbus/TCP.
8. On the read-only Modbus/TCP Network
Configuration screen, press Edit
If the Modbus/TCP network has not been
configured, the Modbus/TCP Network Not
Configured screen displays. Press Configure
9. On the editable Modbus/TCP Network
Configuration screen, change the network
configuration settings for Port 2.
NOTE: NOTE: NOTE: Do not modify these settings from the
default provided on this page without contacting
Graco. Otherwise, the Touchscreen Module
cannot control or monitor the system.
Field Field Field
IP Address
Subnet Mask
Gateway
DNS1
DNS2
10. Press Apply Apply to enter the changes and have them Apply
take effect .
11. Confirm that communication to the Touchscreen
is working properly.
Edit Config Edit Config. Config
Configure.
Configure
Value Value Value
192.168.1.99
255.255.255.0
0.0.0.0
0.0.0.0
0.0.0.0
3A4030C