Graco 25A693 Instructions Manual page 54

Software Setup
Set Up Up a a a Lenze Lenze Variable Variable Frequency
Set Set Up Lenze Variable
NOTE: NOTE: NOTE: This procedure is only for setting up a Variable
Frequency Drive/Inverter manufactured by Lenze
(Graco part numbers 17N041, 17N042, and 17N043).
For Variable Frequency Drives/Inverters made by
a different company, see their documentation for
complete warnings and operation instructions.
Use this procedure to enter the node ID that
the Intelligent Paint Kitchen software assigned
for each Variable Frequency Drive/Inverter (B)
in the system. In addition to setting the node
ID, each Variable Frequency Drive/Inverter must
be individually configured to take the Variable
Frequency Drive/Inverter out of Local mode and set
it to communicate with the Intelligent Paint Kitchen
software.
When this procedure has been completed, Variable
Frequency Drive/Inverter settings and operation are
controlled from the Intelligent Paint Kitchen software,
with no local control at the Variable Frequency
Drive/Inverter display and keypad.
54
Frequency Drive/Inverter Drive/Inverter for
Frequency Drive/Inverter
Operating the Operating Operating
Keypad
Keypad Keypad
The following steps require you to program
information directly into a Lenze Variable Frequency
Drive/Inverter. Use these guidelines to operate the
Variable Frequency Drive/Inverter keypad:
1. Press
2. Use the
3. When the P-code appears, press
4. Use the
5. When the P-code has been set, press
for Modbus Modbus Communication
for Modbus
the Variable the Variable Frequency Variable Frequency Drive/Inverter Frequency
to put the Variable Frequency
Drive/Inverter in Program mode.
and
P-code, as instructed.
that P-code.
and
as instructed.
to return to the P-code screen. Then continue to
the next P-code to be set.
Communication
Communication
Drive/Inverter Drive/Inverter
keys to navigate to each
to go into
keys to set that P-code
again
3A4030C